Akuma Engine Settings:

General Settings:
Tick Everything
Update Interval:500
Found Address List:1000
Freeze Interval:1

Scan Settings:
[X] Fast scan on by default
[ ] Enable hyperscan when possible
[ ] Don't scan memory that is protected with the No Cache Option
[ ] Keep low memory usage when doing an Unknown Initial Value scan with Hyper Scan

[x] MEM_PRIVATE
[x] MEM_IMAGE
[ ] MEM_MAPPED
[X] Run scan in separate thread.

Thread Priority:HIGHER

File Associations:
Tick Nothing

Code Finder:
[x] Use Debug Registers
[ ] Memory Access Exceptions
[x]Try to prevent detection of the debugger
[ ] Handle breakpoints not caused by CE

Assembler:
[x] Show disassembler
[x] Show debugger options
[x] Use hardware breakpoints
[ ] Use int3 instructions for breakpoints
[x] Replace incomplete opcodes with nops
[x] Ask for replace with nop
[x] Try to prevent detection of the debugger

Extra:
[ ] Query memory region routines
[x] Read/Write process memory
[x] Open Process

[ ] Use APC to inject dlls
[ ] Use APC to create new threads
[ ] Undo changes to CE
[ ] Force memory to be writable in case the standard method is blocked
[x] Enable use of Process Watcher
[x] Use kernel debugger options when possible

[ ] Stealth mode (Usermode)
[X] Stealth mode (Kernelmode)


If this procedure it done perfectly, you should have a bypassed engine!